Since RC is down and I used to post here almost exclusively.... I'll re-post my question:
I need a very high head pump.
I need to push water through a 1" tube up a good 15' and horizontally a good 25' or so.
I'm going to need 2 45 bends (if I can get away with that), and three 90 degree bends.
My overflow can handle around 1400 gph, although I should go under a little since I am adding a asurge.
Efficient and low heat would be nice, submersible is necessary.
Suggestions?
I need a very high head pump.
I need to push water through a 1" tube up a good 15' and horizontally a good 25' or so.
I'm going to need 2 45 bends (if I can get away with that), and three 90 degree bends.
My overflow can handle around 1400 gph, although I should go under a little since I am adding a asurge.
Efficient and low heat would be nice, submersible is necessary.
Suggestions?